No communication with EVM Gas gauge could be established (bq34z100EVM and EV2300)

Hi.

I have simply installed the bq34z100 evaluation SW ("bqEVSW") and the corresponding 32-bit driver for my windows 7 (and resterted my PC). Then I have connected my bq34z100 evaluation module ("bq34z100EVM") through my EV2300. The EV2300 is connected to the bq34z100EVM using I2C (the "mid" EV2300 contact).

Now, I simply want to check if I have installed the "bqEVSW" SW correctly and that the "bqEVSW" have connection to my bq34z100 evaluation module ("bq34z100EVM") through the EV2300. The EV2300 is connected to the bq34z100EVM using I2C (the "mid" EV2300 contact).

But when I launch the "bqEVSW", the following is shown first:

Image may be NSFW.
Clik here to view.

NOTE: It says "AutoDetect device: None" etc.
I then click "Confirm Selection", and the following pop-up appears: 

Image may be NSFW.
Clik here to view.

Does this indicates some initial errors (in case what) ?

I hope someone can help me clarifying the situation.

Regards Terje Bohler