Dear TI
I have some problems configuring the device,When I open the Evaluation software the Bq34 is found and the sofware opens up,in the left coner the sofware writes "Communication OK",However see attached screen print when I click on an data element(one of the parameters) a little window opens which shows the current value, in this element,I then for example the OTthershold default is 60 I type in 70.0 and click OK, then a popup window opens and report type mismatch ,I then tried Hex numbersbut that also dont work ,what could be the problem ? Also is there some where a basic getting started manual for this software and the device as it is very new. I am affraid I have no idee were to start and how to configre the device for my battery pack (this is quite different to the BQ78412) secondly what would be the logical work flow with the device .
Any help is appreciated
Regards
Peter