Hi,
I have an issue after performing an OC test.
Set to cut off at 50A load, recover at 200mA after 8s.
this is a screenshot of after load, the gas gauge does not recover, and a few data's and flags did not recover as well.
I have to key in the RESET (0x0041) code into the Manufacturing Access to manually reset the data. this causes the FAS and SS to set in again. Here is a screenshot of it after RESET.
Could anyone help to verify this? This does not happen on earlier testings. Is it a mistake in the data flash setting that could cause this error?
any guidance would be appreciated.
Thanks!