I Have been working on bq77910A for my applications. During setting of current thresholds I set the OC discharge current threshold at 200 but actually the hardware operates the fet at 100A. I used 5 mohm sense resistors five in number and they are in parallel which makes it to 1 mohm. But why the circuit do not operates at actual values. Also I select SOR bit set to logic 0 so that fets immediately gets ON after OC & SC condition, Also this is not happening, it requires reset manually by attaching wakeup resistor b/w CHGCTL & Pack/Batt+. Kindly Suggest some Reasons for above conditions
Regards,
Mohit