Hello,
I use bq20z75-v180 with EVSW bq20z75 v1.81.
After setting values in DF to appropriate and calibration, I exported DF to GG file. When I import the GG file to load data to another bq, I receive message four times: "The value you entered is not allowed because it results in code(decimal) 11 Division by zero". As I see four values are set to zero in EVSW after I imported gg file: CC Gain, CC Delta, CC offset, Board Offset. In GG file all the values are not zero.
Why there are these errors? How to solve this problem? GG file attached.
Waiting for your answer.