Hi TI,
As per data sheet it is mentioned "Upon detecting A/D value representing 2.5 V on VEN pin, Four-LED mode will display the RSOC by driving pins RC2(LED1), RC0(LED2), RA1(LED3),RA2(LED4) in a proportional manner where each LED represents 25% of the remaining state of charge. For example, if RSOC = 67%, three LEDs will be illuminated."
Should it be 75% instead of 67% if three LEDs are ON ?
Also please confirm the below:
One LED ON: 25% ROSC
Two LEDs ON: 50% ROSC
Three LEDs ON: 75% ROSC
Four LEDs ON: 100% ROSC (Full Battery Condition)
Please reply ASAP.
Regards,
Deepak Holla.