UCC28740: SIMPIS UCC28740 SIMULATION NOT WORKING

<<<<<<<< Error Message ID: 1023 >>>>>>>>

input file C:/Users/DELL/Desktop/SIMPLIS_Data/0.deck, line 63:

X$U1 22 0 25 29 26 24 11 UCC28740

Unable to locate the definition

of 'subcircuit UCC28740' in the

input, include, or library file(s).

On SIMetrix/SIMPLIS , Version : 8.20h

*** END SIMPLIS ERROR REPORT ***

1. The UCC28740 SIMPLIS Transient Model is encrypted and runs only in SIMPLIS versions 7.2d and above.

2. The testbench has been configured to show the Startup for VIN=200V,VOUT=5V , 10W, Iout of 2A

3. Please refer to datasheet for operating range.

4. All transients can be applied after the output voltage reaches steady-state.

so I just wanna know that the attached design example file test bench only work for this specific range of VIN= 200V , VOUT=5V,10W, Iout=2A or can I manipulate by using ucc28740 in a different design challenge ? If there is a specific range than how can I change the range of this test bench to design my power supply using UCC28740?