BQ34Z100 Impedance Track is ? 0x0021, 0x06 ?

Hi  

Tom

Table 4. CONTROL_STATUS Flags

                       Bit 7      Bit 6              Bit 5               Bit 4              Bit 3             Bit 2               Bit 1           Bit 0
High Byte —               FAS               SS             CALMODE      CCA             BCA              CSV              —
Low Byte — —                       FULLSLEEP      SLEEP           LDMD         RUP_DIS       VOK             QEN    

                                                                                                                                 ?                 X                    O K

Whentheload0x0021torunafterdischarge
SET 1will be marked asRUP_DIStheVOKSET 0QENSET 1will be displayediteupnida.
 
Would like to askthat0x04from0x06toberecognizedmultiple times andthedegree ofcharging and discharging.

**Right nowthecharge and dischargetimesanditeupnida.**

0x04 Impedance Track is enabled but Qmax and Ra data are not yet learned.
0x05 Impedance Track is enabled and only Qmax has been updated during a learning cycle.
0x06 Impedance Track is enabled.Qmax and Ra data are learned after a successful learning cycle.This
should be the operation setting for end equipment.

 I'm very much obliged to you.

SHIN