Hello,
Question 1:
Minimum rated cell voltage is required by bqEasy, but my cell datasheet only gives nominal voltage (3.7V), can I use the nominal voltage as minimum cell voltage?
Question 2:
After battery was fully charged (100% fuel gauge), load test behavior was strange, capacity down to 75% immediately, discharging from 75% to 0% was close to calculated time. could it be caused by battery cell characteristics setting? if so what parameter could cause this behavior?
Question 3:
In my other post, I asked how bq27510-g2 indicates SOH, I could not find any key word about SOH in its datasheet, could you please also advise SOH implementation by using 27510?
Best regards,
Yunfa Yang