Part Number:TPS1H100-Q1
Hi all
Would you mind if we ask TPS1H100-Q1?
Table1 shows the operation of /ST signal.
</ST operation in case of TPS1H100-Q1>
No load : Low
With load : High
Short to GND(Current limit) : Low
In case of load, /ST operation was High. Is it correct operation?
</ST operation in case of TPS4HXXX-Q1 or TPS2HXXX-Q1>
No load : High
With load : High
Short to GND(Current limit) : Low
Is it correct operation?
We could not find these description on the datasheet.
Kind regards
Hirotaka Matsumoto