BQ34Z100-G1 RAC and masking alert

Hi

My customer is using the BQ34Z100-G1, in the four LED format, led not always on (LED/COMM Configuration Bit 3 is clear)

We are using the datasheet SLUSBZ5 –JANUARY 2015

He would like to set-up the gauge to  automatically light up the LED when the capacity hits below 25%.

Therefore he needs to onlyset alert for lesser than maybe 25% of batt capacity .

I would like to check with you the following:

• Is the RCA mentioned the datasheet, page 40/60 set by the SOC1 and SOCF (found on page 25)? Is this the right place to set the threshold for less than 25% capacity?
• On table 22, there are a list of alerts that are Or-ed together. How do we mask off the alerts that are not needed?

Ivan