Dear all,
I want to change parameters in ~200 pieces of BQ34z100, but QEN is set in each of them.
Is there another, easier way of changing parameters like "Design Capacity" than:
1. enter ROM mode via EVSoftware an then send *.senc file with update status = 0?
2. program *.gg file with correct parameters
I would like to use microcontroller instead EVSoftware. Becouse I can easily change software in it.
But to connect EVSoftware I need to solder wires to test pads on each board and some of them are coated with resin.
I can program gg file via uC so half of the solution is done. But I don't know how to program *.senc file to that IC
Is anyone know how to program *.senc file to BQ34z100 or know easier solution?
Best regards,
Damian.