BQ34Z100 I2C Multi byte write (incremental writes)

Hello, in the datasheet it says you can only write one byte at a time, if you attempt an incremental write all extra bytes will be be NACK.

This doesn't seem to be the case.

When I use the BQEV software I can send 2 byte words to an address and there is no NACK.

I am trying to unseal a pack and I can only unseal it using the BQEV software when I send 16bit words, these apparently can't be sent according to the data sheet.

The scope shows, AA, 00 , 14, 04, this is clearly a multi byte message. Am I misunderstanding the datasheet?

If I send them one byte at a time to address 0 then address 1, the unseal doesn't work.

Perhaps you can shead some light on this.

Thanks

Morgan