Part Number: BQ25601D
Hello,
I am trying to use the BQ25601D to charge the battery of my prototype. Here you can see the schematics:
Just the same that I did on Webench.
I have configured the registers by i2c, but the charging is not going higher that 0.5A. I am using a 2.5A charger and trying to charge the battery at least with 2A.
The charger has been configurared as non standard using a voltage divider to have 2.7V on D- and D+. I can see this right on REG08(0xD4).
Could someone give me any advise why the current at the battery is only 0.5A while all the registers seems to be right to charge it with 2A?
Thanks in advantage.