BQ40Z60 - where I shuld change parameters to incrise discharge current?

Hi everyone,

I would like increase discharge current in BU40Z60 but I can't found where.

I use Battery Management Studio.

Now when I try get more that 2A, Bq40Z60 set up bit SS (Safety Mode) in Operation Status register.

Moreover In Safety Status registry I have set up AOLDL bit and per mayby 2s setup AOLD bit.

In Protection I have OCD1 and OCD2 set on -9000mA, OCD on 4000mA but still BQ is turn off output when I try get more that 2A.