Hi, Thomas,
Need your help about bq40z60. I am trying to setup the charging current from low to high. The initial charge current I set is ~250mA - 500mA, but after enabled the charging, its current only shows couples mA, sometimes I saw ~10mA. Could you please help me to check it out? The attached are the capture bqStudio images.
Thanks
L.
For some reason the former loaded register img are all GRN. Here I uploaded again.
From the register info its charging is Inhibit due to the High Temp, even after I reconnected the battery pack and its temp is back to normal status. How to remove this HT and IN status?