Hi all,
I have a problem, I'm using a high current system with I > 32.767A. So I have a Shunt resistor with 3.3mOhms value. After current calibration I have CC Gain = 2.827 and CC Delta = 2.822.
After that, I write an optimized firmware in bq and when I try to write with bq studio CC Delta = 2.822 I have this message : "Value is beyond maximum value defined parameter". But it is the value finding by bq!
My question is, how to write my right value?
And after that, the problem is when I will calibrate 20 sample boards for current average calibration value. How I can send the good value if CC Delta is limited?
Regard, and thank you for your help,
Loïc