I have a BQ24250 with 4.99V in, and a single cell connected. It is being driven in I2C mode at 100Khz.
Single cell is at 3.65V.
EN1 and EN2 are at GND
536ohm resistor on ILIM
I think this should be charging at 500mA, but I keep getting "no battery connected faults" Suggestions?
FYI. Here are the register contents:
Charger Registers:
0 0x38
1 0x8C
2 0x8C
3 0x01
4 0x02
5 0xA8
6 0xE0