Hello guys.
Finally I got EV2300 and did set all the batt parameters and Calibration. I have a few questions, thanks for answers in advance.
1. I went through Step by step Design Procedure and went to Preparing Optimized Default Flash... (SLUA334B) and not sure what is step 3.5 - Write a .senc file with the correct chemical ID to clear the hidden data-flash constants. Could you pls. explain this step?
2. In same document in step 3.7 this means to save golden Image, correct? As now it has extension .srec
3. CC offset can not be modified. I was able to modify it on bq34z100. Is this ok? I have value there -1414 for G1
4. When I set SCALE flag, should also Current reading be multiplied by Design scale number? Does it mean I can run more then 32.76A over Shunt resistor when max voltage between SRP and SRN maintained under 0.125V?
My setup:
Chem ID: 0x2020 (Panasonic NCR18650PF 13S3P)
Design Capacity: 8640 mAh
Design Energy: 32000 mWh
Pack config A - SCALED: 0 VOLTSEL:1
Series Cell:13
Qmax Cell0: 8640
CC gain: 5.24
CC Delta: 5.229
Board offset: -72
Volt divider: 56088
Thanks