BQ34Z100-G1 Step-by-Step Design

Hi,

I have a question regarding section 9.2.2.1.4 of the BQ34Z100-G1 datasheet. I am using a 1 mohm current sense resistor in my design, should I enter the value "1" into both CC Gain and CC delta parameters via bqStudio? 

After I entered in the correct value for CC gain and CC delta, I am guessing I should not need to change the default value for CC offset (-1426), I should be able to use bqStudio to run a CC offset calibration, is it correct?

Thanks,

Jeff