Dear Sirs;
I have no experience with Gauge bq34z100-g1 and I need help to program it and put it to run.
My battery is lead acid 12V 7A / 20H, MODEL 6FM7 NLD POWER, www.indpower.com.
The resistive divider to the ci bq34z100-g1 pin 4 is 253K and 16K5 and the shunt resistor used is 100m Ohm. The resistive divider this directly connected to the battery without control pin 2, VEN.
I will not use LEDs, communication with the microcontroller is just the I2C signals SDA and SCL.
Can You send a procedure for programming this registers step-by-step, with all values values ?
This procedure must enter all necessary actions to set the Gauge bq34z100, step by step.
Sure your attention, thank you in advance.
Best regards;
Adilson Medeiros