What are the required pack configuration register settings needed to get the SE pin to toggle from a HIGH to a LOW when the SOC1 flag changes state?
I can manually toggle the pin through the bqStudio interface connected to an EV2400 module that is connected via I2C to my application circuit, and I can see the SOC1 flag change state in the bqStudio display when it should during battery discharge. I know the chip and the SE pin physically work.
I can toggle registers, I have the actual gas gauging function working properly, etc., I just cannot seem to make the SE pin toggle from SOC1 changing state during discharge.
What am I doing wrong? I do not see what is wrong with the register settings I'm using based on what I have read in all the documentation for this part.
Any help is appreciated. Thank you.
-David