Part Number: TPS3808
I have these monitors on one of my boards and they have been working really well for at least 60 boards. However, one board I notice is stuck in a reset loop. The +5V TPS3808 monitor is blinking the LED probably like 4-5 times a second. The voltage on the input is a steady +5V. The MR input is just floating. Same with the CT pin (default delay). Unless something is pulling down the output (mosfet gate to drive LED and an AND gate input), I'm not sure why it's doing that. I'll keep debugging and if I figure it out, I'll add the answer.
Thanks,
Vinny