Hi
I want to use an eq34z100evm with an 6-cell li-po battery. Nominal voltage is 22.2V and capacity 6200mAh.
what do i have to consider to setup de evalboard? How do i have to configure the settings, to show de available capacity with the 10 LED's on the board?
i already set the jumpers at J5 to the >5V position and J2 to 32V.
In the Data Memory Field i've entered: number of series cell 6, i set the VOLTSEL bit, design capacity 6200. But when I try to enter in the field design energy the value 137600 (22200mV * 6200mAh) there is an error which says: value is beyond maximum value defined for parameter.
I also calibrated the voltage.
What else do i have to configure?
Thanks for helping me
Manuel