Part Number: BQ40Z80EVM-020
Hi,
I bought a board bq40z80EVM expecting that the IC bq40z80 is able to manage the charge of the batteries. I want to use a configuration of 6s Li-Ion.
Is it correct the following sequence to achieve that result?
- Make a short circuit on the Terminal Block Connections between 6P and 7P on J12.
- Connect the usb to the PC
- Load the appropiate configuration for the battery pack
- Connect a power supply to the PACK+ and PACK– with a voltage > 25,2 (and less than?)
- Press SYS PRES.
Should I connect on PACK+ and PACK– to a smart-charger or is it sufficient a normal power supply?
How can I drive the board to charge the batteries by means the "Battery Management Studio"?
Thanks,
Fabrizio.