I have a custom PCB with BQ28Z610 as the gas gauge to be used with a Single Cell. I don't have access to I2C connections from outside, but have them connected to the Micro Controller. The chip comes with 2 Cell configuration from factory. Can I set it up to single cell using the micro controller, without using EV2300/EV2400 and TI Software?
If I send proper I2C commands to the gas gauge would this work? When I address data flash, do I send the data flash address as LSB first or MSB First? Is there any specific sequence I have to follow?
Thank you,
Tharaka.