Dear TI,
I have a BQ34Z100-G1 IC connected on my own PCB design, and I'd like to set some configurations and calibrations in the IC through I2C. The user guides mention how to do this with BQ34Z100-G1-EVM and the EV2300 module through the Battery Management Studio GUI. However, I would like to configure the BQ34Z100-G1 IC on my board directly through the EV2300 and Battery Management Studio.
I have I2C pins available to directly connect to the BQ34Z100-G1 IC from any external source (like the EV2300), so that shouldn't pose a problem. And if I would like to automate the configuration of this IC, could I do that with a simple script which is run from anything like an MCU, Raspberry Pi, Arduino, etc.?
Kind regards,
Javier