Table 21 of the datasheet has a column called "Config Register Hex Code".
Based on the LED mode used, a value is given. In my case, I'm using Mode 3 with the 10-LED Expander with I2C.
In bqStudio, in Data Memory/Configuration/Registers/Alert Configuration I have set the value 0x93 as indicated by Table 21.
When I look at the register, only for bits are set: OCVTAKEN, CF, EOD, and DSG.
My question is that I am unclear as to what this means. Are only those bits available as alerts? Can I not set other bits if I need them? If I can set other bits, then why is the column called "Config Register Hex Code" even there?
Could you please expand on this?
Thank you.