Dear e2e team,
I have been working with BQ34Z100-G1. We have a .srec file of already working BQ34Z100-G1. In that chip all the procedures and learning cycle is done
successfully.
We exported that .srec through Golden Image option of BQstudio tool and it created the Golden file successfully,
We then flashed the .srec file again in our new BQ34Z100-G1 chip. It flashed successfullym but once after 3 seconds the chip detection is stopped
and it didnt detect nor I can able to flash the original Bq34Z100-G1 firmware to the IC.
It always says no acknowledge from the device.
Seems like something got corrupted in the IC. IC deosnt seem like it gone bad, but still cant figure out the issue.
Does this issue have anything to do with the way we created the Golden Image.
I opened the exported files ".gg.csv" I found that Uddate status Register has been set as 06. Whether that is caused this issue.
do I have to set different value before creating the Golden Image file ?
Please clarify.
Thanks & Regards
Sarjoon