I am using the EVSW V.0.9.88 to program bq27541V200 parts. When I open the DATA FLASH tab and look at subclass CONFIGURATION subclass DATA I see the locations as I expect to see based upon the data sheet SLUSA11A, page 20 Table 7, but also in the same Subclass DATA I see two spots to enter SERIAL NUMBER and DATE OF MFG. They are located between the Initial Max Load and Cycle count. I know it works because I can set that data and then read it back and its valid. Since its not referred to in the data sheet, I don't know where it is storing these two pieces of data. Since I don't know where it is putting it, I don't know how to read it back with my host.
Please tell me where this is being stored by EVSW.
Oddly, when I look at SLUA561B "configuring the bq27541-v200 data flash" document, it shows a screen shot of the EVSW that does not include the ability to set serial number or date of mfg in the DATA subclass.
thanks
dpk
