i'm using bqEASY with bq27510-G2. Here's the steps
1) put device in rom mode with - i2c command: 00, Data block: 000f
2) program new .senc file, software indicated download was success
3) power cycled board - i'm not sure if this is where I messed up. i didn't press "execute" in bqEasy. i thought a power cycle would cause the new .senc to execute.
4) went thru bqEASY steps and selected chem ID 1107. Software took a while writing to the device
result: chemID has not been updated in data flash. it still reads 0100. what is wrong?