Dear Tom,
I am testing a system that runs on three NiMH V600 HR in series and I am using the BQ34z100-G1 as a battery monitor. I configured the monitor following the steps in the BQ34z100-G1 datasheet and set the battery chemistry to 0x6107, calibrated the board following sluu904a and started learning Qmax following the procedure slua334b.
However, after the voltage calibration step Voltage() returns the correct voltage but during discharge it diminished way too quickly comparing to the actual voltage over the battery. It also seems that Qmax never gets updated during the slua334b procedure, although the OCVTAKEN bit will get set.
I have attached the settings, Please, can you help me out?
Regards,
Wouter
(Please visit the site to view this file)