Dear BQ Experts,
on behalf of my customer I'd appreciate if you could take a look on below:
==============================================
we are using a TI BQ34Z100 Fuel Gauge Sensor in our Application.
In our tests we noticed some strange behavior.
Often the state-of-charge changed its value over night from circa 15% to circa 7% (and backwards) without any load.
Also the state-of-charge wasn’t stable. So it varied highly in the range between 5% and 25%.
Is this a normal behavior of this sensor? Maybe our flash settings are not correct. I send you the configuration settings as well.
A possible option is to use the BQ34Z100-G1 instead. Is there anything else changed in this new sensor than the bugfix for the ALERT-pin?
==============================================
There are already e2e posts about a migration to the -G1, but the answer is only posted offline. Appreciate if you could add this as well.
Best regards,
Uli