Hi,
I have the bq20z65EVM gas gauge that I am trying to set up with my cells. I am using the bqEVSW software to calibrate and the bqEASY to set all of the parameters. I am having a problem while trying to perform the voltage calibration. Every time I try the voltage calibration, I get a message saying "Calibration failed! Error Code = Error Code (decimal) 5024". Here is my setup:
- 12 V between Pack+ (+) and Pack- (-) to power the board
- 1 A current between 1N (-) and Pack- (+) to simulate discharge
- 1K Resistors between cell ports on board (I have tried with and without these resistors and get the same message)
Every other calibration works fine, and I have been able to flash parameters to the gas gauge using bqEASY. The only problem that is preventing me from getting this working is the voltage calibration. Does anyone know what the error means, or what I am doing wrong?
Thanks in advance,
Dylan